Operation Manual

788| Effects for the Sounds
i [P]Manual 0…100 Sets the frequency to which the
effect is applied
Depth 0…100 Sets the depth of LFO modula-
tion
Resonance –100…+100 Sets the resonance amount
j [P]Phaser Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the phaser effect balance
Src Off…Tempo Selects the Wet/Dry modulation
source for the phaser
Amt –100…+100 Sets the Wet/Dry modulation
amount for the phaser
k [P]Output Mode Normal,
Wet Invert
Selects the phaser output mode
Routing OD/HG › Phaser,
Phaser › OD/HG
Switches the order of the over-
drive and phaser
l Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
OD/HG - Mt.Delay (Overdrive/Hi.Gain - Multitap Delay)
This effect combines a mono overdrive/high-gain distortion and a multitap
delay.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Multitap Delay
Feedback
High Damp
Delay
(2)
(1)
Mt.Dly FX Amt
Overdrive / Hi-Gain
3 Band PEQ
Output Level
Mode: Overdrive / Hi-Gain
Drive
Driver
OD/HI-GAIN
a [O]Drive Mode Overdrive, Hi-Gain Switches between overdrive and
high-gain distortion
Drive 1…100 Sets the degree of distortion