Operation Manual

Effect parameters |777
Limiter - Phaser
This effect combines a mono limiter and a phaser. You can change the order
of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Limiter
Limiter
Gain Adjust
Envelope - Control
Phaser
Phaser
Resonance
LFO: Tri / Sine
Phaser FX Amt
Normal
Wet Invert
Output Mode
–
+
LIMITER
a [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
Threshold [dB] –40…0 Sets the level above which the com-
pressor is applied
b [L]Attack 1…100 Sets the attack time
Release 1…100 Sets the release time
c [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
PHASER
d [P]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
e [P]Manual 0…100 Sets the frequency to which the ef-
fect is applied
Depth 0…100 Sets the depth of LFO modulation
Resonance –100…+100 Sets the resonance amount
f [P]Phaser Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the phaser effect balance
Src Off…Tempo Selects the phaser’s Wet/Dry modu-
lation source
Amt –100…+100 Sets the phaser’s Wet/Dry modula-
tion amount
g [P]Output Mode Normal,
Wet Invert
Selects the phaser output mode
h Routing Limiter › Phaser,
Phaser › Limiter
Switches the order of the limiter and
phaser