Operation Manual

776| Effects for the Sounds
LIMITER
a [L]Ratio 1.0 : 1…
50.0 : 1, Inf : 1
Sets the signal compression ratio
Threshold [dB] –40…0 Sets the level above which the com-
pressor is applied
b [L]Attack 1…100 Sets the attack time
Release 1…100 Sets the release time
c [L]Gain Adjust [dB] –Inf,
–38…+24
Sets the limiter output gain
CHORUS/FLANGER
d [F]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
LFO Waveform Triangle, Sine Selects the LFO Waveform
e [F]Delay Time [msec] 0.0…1350.0 Sets the delay time
Depth 0…100 Sets the depth of LFO modulation
Feedback –100…+100 Sets the feedback amount
f [F]EQ Trim 0…100 Sets the EQ input level
g [F]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
h [F]Cho/Flng Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Sets the effect balance of the chorus/
flanger
Src Off…Tempo Selects the Wet/Dry modulation
source for the chorus/flanger
Amt –100…+100 Sets the Wet/Dry modulation amount
for the chorus/flanger
i [F]Output Mode Normal,
Wet Invert
Selects the output mode for the cho-
rus/flanger
Routing Limiter ›
Flanger,
Flanger ›
Limiter
Switches the order of the limiter and
chorus/flanger
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry sig-
nal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source