Operation Manual

Effect parameters |767
COMPRESSOR
a [C]
Sensitivity
1…100 Sets the sensitivity
b [C]Attack 1…100 Sets the attack level
Output Level 0…100 Sets the compressor output level
c [C]EQ Trim 0…100 Sets the EQ input level
d [C]Pre LEQ Gain [dB] –15…+15 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15…+15 Sets the gain of High EQ
WAH
e [W]Frequency Bottom 0…100 Sets the lower limit of the wah center
frequency
Frequency Top 0…100 Sets the upper limit of the wah center
frequency
f [w]Sweep Mode Auto,
D-mod,
LFO
Selects the control from auto-wah, mod-
ulation source, and LFO
Src OffTempo Selects the modulation source for the
wah when Sweep Mode=D-mod
g [W]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
Resonance 0…100 Sets the resonance amount
LPF Off, On Switches the wah low pass filter on and
off
h [W]Wet/Dry Dry,
1 : 99…99 : 1,
Wet
Sets the wah effect balance
Src OffTempo Selects the Wet/Dry modulation source
for the wah
Amt –100…+100 Sets the Wet/Dry modulation amount for
the wah
i Routing Comp › Wah,
Wah › Comp
Switches the order of the compressor
and wah
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src OffTempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source