Operation Manual

696| Effects for the Sounds
c [W]LFO Frequency [Hz] 0.02…20.00 Sets the speed of the LFO
Resonance 0…100 Sets the resonance amount
LPF Off, On Switches the wah low pass filter on
and off
d [W]Wet/Dry Dry, 1:99…99:1,
Wet
Sets the wah effect balance
Src Off…Tempo Selects the Wet/Dry modulation
source for the wah
Amt –100…+100 Sets the Wet/Dry modulation
amount for the wah
AMP SIM
e [A]Amplifier Type SS, EL84, 6L6 Selects the type of guitar amplifier
f Routing Wah › Amp, Amp
› Wah
Switches the order of the wah and
amp simulation
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
Decimator - Amp (Decimator - Amp Simulation)
This effect combines a mono decimator and an amp simulation. You can
change the order of the effects.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Decimator
Routing
Amp Simulation
Amp Simulation Filter
Pre LPF
High Damp
Output Level
Decimator
Resolution
DECIMATOR
a [D]Pre LPF Off, On Turn the harmonic noise caused by
lowered sampling on and off
High Damp [%] 0…100 Sets the ratio of high-range damp-
ing