Operation Manual

Effect parameters |695
h [O]Wet/Dry Dry,
1 : 99…99 : 1,
Wet
Sets the overdrive effect balance
Src Off…Tempo Selects the Wet/Dry modulation source
for the overdrive
Amt –100…+100 Sets the Wet/Dry modulation amount for
the overdrive
i Routing Comp › OD/HG,
OD/HG › Comp
Switches the order of the compressor
and overdrive
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
Wah - Amp Sim (Wah - Amp Simulation)
This effect combines a mono wah and an amp simulation. You can change
the order of the effects.
FX Amt
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
Routing
Amp Simulation
Amp Simulation Filter
Wah/Auto Wah
Wah
D
-mod
Envelope
Sweep Mode
D-mod
Auto
LFO
LFO
WAH
a [W]Frequency Bottom 0…100 Sets the lower limit of the wah center
frequency
Frequency Top 0…100 Sets the upper limit of the wah cen-
ter frequency
b [W]Sweep Mode Auto,
D-mod,
LFO
Selects the control from auto-wah,
modulation source, and LFO
Src Off…Tempo Selects the modulation source for
the wah when Sweep Mode=D-mod