Operation Manual

Effect parameters |615

g Feedback –100…+100 Sets the feed back amount of the chorus

block

High Damp [%] 0…100 Sets the high range damping amount of the

chorus block

h Low Level 0…100 Sets the low range output level

High Level 0…100 Sets the high range (chorus) output level

i Wet/Dry Dry, 1:99…99:1,

Wet

Balance between the wet and dry signal

Src Off…Tempo See DMS (Dynamic Modulation Source)

Amt –100…+100 Amount of modulation source

f: High/Low Split Point

This parameter sets the frequency that splits the high and low range. Only

the high range will be sent to the chorus block.

g: Feedback

Sets the feedback amount of the chorus block. Increasing the feedback will

allow you to use the effect as a ﬂanger.