Operation Manual

608| Effects for the Sounds
e Feedback
(C Delay)
–100…+100 Sets the feedback amount of TapC
Src Off…Tempo Selects the modulation source for the
TapC feedback
Amt –100…+100 Sets the modulation amount of the TapC
feedback
f High Damp [%] 0…100 Sets the damping amount in the high
range
Low Damp [%] 0…100 Sets the damping amount in the low
range
g Input Level Dmod [%] –100…+100 Sets the modulation amount of the input
level
Src Off…Tempo Selects the modulation source for the
input level
h Spread 0…50 Sets the width of the stereo image of the
effect sound
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Time Over?
You can set the delay time up to 10,920msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.