Operation Manual

602| Effects for the Sounds
d Loop Base Note
…
Selects the type of notes to specify the
delay time
Times x1…x32 Sets the number of notes to specify the
delay time
e REC Control Src Off…Tempo Selects control source for recording
f RST Control Src Off…Tempo Selects control source for reset
g Manual REC Control REC Off,
REC On
Sets the recording switch
h Manual RST Control Off, RESET Sets the reset switch
i Pan L100…L1, C, R1…
R100
Sets the stereo image of the effect
Src Off…Tempo Selects the modulation source of ste-
reo image of the effect
Amt –100…+100 Sets the modulation amount of stereo
image of the effect
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
a: Loop Time [msec]
With Auto, the loop time is automatically set. Otherwise, you can specify the
loop time.
When Auto is selected, the Loop Time is automatically set to the time it takes
for a performance recorded while the Modulation Source or “Manual REC
Control” is on. However, if the time length exceeds 10,800msec, the loop
time will be automatically set to 10,800msec.
c: Time Over?
You can set the delay time up to 10,800msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.