Operation Manual

Effect parameters |601
d Low Damp [%] 0…100 Sets the damping amount in the low range
e Input Level Dmod –100…+100 Amount of input level modulation
Src Off…Tempo Selects the modulation source of Input
Level Dmod. See DMS (Dynamic Modulation
Source)
f Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
Hold Delay
This effect records the input signal and plays it back repeatedly. You can
control the start of recording and reset via a modulation source. Easy to use
for real-time performances.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
Pan
Delay
D
-mod
D
-mod
Loop Time: Auto/ ...5400ms
+
Tempo
BPM
BPM
Base Note x Times
REC Control
RST Control
a Loop Time [msec] Auto, 1…10800 Sets Automatic loop time setup mode
or specifies loop time
b Loop BPM Sync Off, On Specifies whether delay time is set in
milliseconds, or as a note value relative
to tempo
c BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Time Over? ---, OVER! An error indication that appears if de-
lay time exceeds the upper limit when
MIDI/Tempo Sync=On