Operation Manual

600| Effects for the Sounds
b: Time Over?
You can set the delay time up to 5,400msec. If the delay time exceeds
this limit, the error message “OVER!” appears in the display. Set the de
-
lay time parameters so that this message will not appear. “Time Over?”
is only a display parameter.
Classic Tape Echo
This models a famous analog tape echo unit. On the original device,
“echo” was created by a playback head, and the “delay time” was speci
-
fied by adjusting the speed of the motor. The warmth and subtlety of
the echoes it generated made this “lo-fi” unit a favorite with many pro
musicians.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Delay
Feedback
Low Damp
Tone
Input Level
D-mod
a Time 0…2700 This parameter sets the delay time.
Src Off…Tempo Selects the modulation source of Time
Amt –100…+100 Sets the depth by which Time will be modu-
lated
b Feedback 0…100 Sets the amount of feedback
Src Off…Tempo Selects the modulation source of feedback
amount
Amt –100…+100 Sets the depth by which feedback amount
will be modulated
c Tone 0…99 Sets the tone of the input.
This models the reduced high frequencies
of an analog tape delay, before the satura-
tion stage. Lower settings create a darker
tone.
This cuts the high frequencies in both the
main output and the feedback. Higher set-
tings create a brighter tone.