Operation Manual

Effect parameters |599

g Tap2 Level 0…100 Sets the Tap2 output level

Pan L, 1…99, R Sets the stereo image of tap2

FB Amt –100…+100 Sets the Tap2 feedback amount

h Tap3 Level 0…100 Sets the Tap3 output level

Pan L, 1…99, R Sets the stereo image of tap3

FB Amt –100…+100 Sets the Tap3 feedback amount

i Feedback 0…100 Sets the amount of feedback for Taps 1, 2, and

Src Off…Tempo Selects the modulation source of feedback

amount

Amt –100…+100 Sets the depth by which feedback amount will

be modulated

j High Damp [%] 0…100 Sets the damping amount in the high range

Low Damp [%] 0…100 Sets the damping amount in the low range

k Saturation 0…100 Sets the distortion amount

l Input Trim 0…100 Sets the input gain

Pre Tone 0…100 Sets the tone of the input

m Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation will

occur

Wow Flutter

depth

0…100 Sets the depth of pitch variation

n Wet/Dry Dry,

1:99…99:1, Wet

Balance between the wet and dry signal

Src Off…Tempo See DMS (Dynamic Modulation Source)

Amt –100…+100 Amount of modulation source

a: Tap1 Dmod Src

b: Tap1 Delay Note

b: Times

c: Tap1 Dmod Note

c: Times

If “Tap1 Dmod Src” is Off or the selected modulation is at 0, the delay time

will be the length speciﬁed by “Tap1 Delay Note” and “Times.”

If “Tap1 Dmod Src” is other than Off, the delay time will change so that it

will be as speciﬁed by “Tap1 Dmod Note” and “Times” when the maximum

modulation is reached.