Operation Manual

Effect parameters |595
j L Delay Base Note
…
Selects the type of notes to specify the left
channel delay time
Times x1…x32 Sets the number of notes to specify the left
channel delay time
Feedback –100…+100 Sets the feedback amount of left delay
k R Delay Base Note
…
Selects the type of notes to specify the
right channel delay time
Times x1…x32 Sets the number of notes to specify the
right channel delay time
Feedback –100…+100 Sets the feedback amount of right delay
l Wet/Dry -Wet, -1:99…
Dry…99:1, Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
i: Time Over? L, R
You can set the delay time up to 2,550msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.