Operation Manual

586| Effects for the Sounds

e Tap2 Level 0…100 Sets the Tap2 output level

Pan L, 1…99, R Sets the stereo image of tap2

FB Amt –100…+100 Sets the Tap2 feedback amount

f Tap3 Level 0…100 Sets the Tap3 output level

Pan L, 1…99, R Sets the stereo image of tap3

FB Amt –100…+100 Sets the Tap3 feedback amount

g Feedback 0…100 Sets the amount of feedback for Taps 1, 2,

and 3

Src Off…Tempo Selects the modulation source of feedback

amount

Amt –100…+100 Sets the feedback amount

h High Damp [%] 0…100 Sets the damping amount in the high range

Low Damp [%] 0…100 Sets the damping amount in the low range

i Saturation 0…100 Sets the distortion amount

j Input Trim 0…100 Sets the input gain

Pre Tone 0…100 Sets the tone of the input

k Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation

will occur

Wow Flutter depth 0…100 Sets the depth of pitch variation

l Wet/Dry Dry, 1:99…99:1,

Wet

Balance between the wet and dry signal

Src Off…Tempo See DMS (Dynamic Modulation Source)

Amt –100…+100 Amount of modulation source

a: Delay (Tap1) [msec]

a: Src

a: Amt

b: Tap2 Position [%]

b: Tap3 Position [%]

The delay time for Tap 2 and 3 is speciﬁed as a proportion (%) relative to

“Delay (Tap1).” Even if you use dynamic modulation to control “Delay (Tap1),”

Tap 2 and 3 will change at the same proportion.