Operation Manual

572| Effects for the Sounds
d EQ Trim 0…100 Sets the input level of EQ applied to the
effect sound
e Pre LEQ Fc Low,
Mid-Low
Selects the cutoff frequency (low or mid-
low) of the low-range equalizer
Pre HEQ Fc High,
Mid-High
Selects the cutoff frequency (high or
mid-high) of the high-range equalizer
f Pre LEQ Gain [dB] –15.0…+15.0 Sets the gain of Low EQ
Pre HEQ Gain [dB] –15.0…+15.0 Sets the gain of High EQ
g Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
Reverb Spring
The spring-type reverbs have a different sonic character than hall or room-
type reverbs. They model the spring reverb systems built into some amps.
Reverb – Gate
This effect combines a mono reverb and a gate.
Left
Right
FX Amt
FX Amt
Reverb
Balance
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
LEQ
HEQ
EQ Trim
Reverb
Pre Delay
Envelope - Control
D-mod
Input
Envelope Select
Gate
Input Reverb Mix
Reverb
Gate
Gate+Dmpr
REVERB
a [R]Reverb Time [sec] 0.1…10.0 Sets the reverberation time
High Damp [%] 0…100 Sets the damping amount in the high
range