Operation Manual

570| Effects for the Sounds

Early Reﬂections

This effect is only the early reﬂection part of a reverberation sound, and

adds presence to the sound. You can select one of the four decay curves.

Left

Right

FX Amt

FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out

EQ Trim

Pre Delay

Early Reflections

LEQ HEQ

a Type Sharp, Loose,

Modulated,

Reverse

Selects the decay curve for the early

reﬂection

b ER Time [msec] 10…800 Sets the time length of early reﬂection

c Pre Delay [msec] 0…200 Sets the time taken from the original

sound to the ﬁrst early reﬂection

d EQ Trim 0…100 Sets the input level of EQ applied to the

effect sound

e Pre LEQ Fc Low,

Mid-Low

Selects the cutoff frequency (low or

mid-low) of the low-range equalizer

Pre HEQ Fc High,

Mid-High

Selects the cutoff frequency (high or

mid-high) of the high-range equalizer

f Pre LEQ Gain [dB] –15.0…+15.0 Gain of the Low EQ

Pre HEQ Gain [dB] –15.0…+15.0 Gain of the High EQ

g Wet/Dry Dry, 1:99…99:1,

Wet

Balance between the wet and dry signal

Src Off…Tempo See DMS (Dynamic Modulation Source)

Amt –100…+100 Amount of modulation source