Operation Manual

Effect parameters |567

Reverb Dry Plate

This plate reverb simulates dry (light) reverberation.

Left

Right

FX Amt

FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out

EQ Trim

LEQ HEQ

Pre Delay

Reverb

Pre Delay Thru

a Reverb Time [sec] 0.1…10.0 Sets the reverberation time

High Damp [%] 0…100 Sets the damping amount in the high range

b Pre Delay [msec] 0…200 Sets the delay time from the dry sound

Pre Delay Thru [%] 0…100 Sets the mix ratio of non-delay sound

c EQ Trim 0…100 Sets the EQ input level

d Pre LEQ Fc Low,

Mid-Low

Selects the cutoff frequency (low or mid-

low) of the low-range equalizer

Pre HEQ Fc High,

Mid-High

Selects the cutoff frequency (high or mid-

high) of the high-range equalizer

e Pre LEQ Gain [dB] –15.0…+15.0 Sets the gain of Low EQ

Pre HEQ Gain [dB] –15.0…+15.0 Sets the gain of High EQ

f Wet/Dry Dry,

1:99…99:1, Wet

Balance between the wet and dry signal

Src Off…Tempo See DMS (Dynamic Modulation Source)

Amt –100…+100 Amount of modulation source

b: Pre Delay [msec]

b: Pre Delay Thru [%]

The “Pre Delay” sets the delay time to the reverb input, allowing you to con-

trol spaciousness.