Operation Manual

Editing the Voice effects |547
Editing the μMod effect
While in the Voice Preset > uMod page, you can program the micro-modu-
lation effect.
μMod is short for micro-modulation. The μMod effect is capable of creating
many different sounds that range from subtle but lush thickening to cre-
atively destructive. It uses a combination of stereo pitch shifting (Detune),
small amounts of stereo delay (Delay), and then a complex path of filtering,
feedback, and modulation. μMod does a faithful job of emulating classic de-
tune, chorus, flange and thickening sounds.
Choosing the μMod set
▪ Use the Set pop-up menu to choose settings for the μMod block.
Adjusting the level
▪ Use the Level parameter to adjust the level for the μMod effect.
Editing the μMod parameters
▪ Use the Speed parameter to set how fast the delay time modulation occurs.
In order for this to be audible, the depth amount parameter has to be non-
zero. The setting range is 10.00 Hz (very fast) to .05 Hz (very slow).
▪ Use the Detune L/R parameters to apply a small amount of pitch shift to
the left or right sides independently. This setting is shown in cents and the
maximum is +/- 25 cents.
▪ Use the Depth L/R parameters to set the amount of modulation of the delay
time for the left and right delays. If one delay is set to 10mS, for example, a
setting of 50% will vary the delay time between 15mS and 5mS at the rate
set by the Speed parameter.