User's Manual
Table Of Contents
- Table of Contents
- Introduction
- Panel description and functions
- Operation Guide
- Parameter Guide
- Appendix
66
MISC
PROG PITCH (Program Pitch)
TRANS (Transpose)
Adjusts the overall pitch in semitone steps over a range of ±1 octave for the entire program.
OCT (Octave)
is sets the basic pitch, in octaves. e default is 0.
BEND (Pitch Bend Up)
is sets the maximum amount of pitch bend, in semitones, when you move the wheel above the
center point. For normal pitch bend, set this to a positive value.
BEND (Pitch Bend Down)
is sets the maximum amount of pitch bend, in semitones, when you move wheel below the center
point. For normal pitch bend, set this to a negative value.
LFO1 (LFO1 Int)
is controls the initial eect of the LFO1 on the pitch, in semitones.
CTRL (LFO1 Ctrl Src)
Selects the modulation source that controls the LFO1 Int. e source value selected here is multiplied
with LFO1 Int to determine the depth of the modulation eect. (See “Control Source List”, p.78)