User's Manual

44
OPERATORS: PITCH
PITCH: OP1...6 (Operator Pitch)
FREQ (Frequency Mode)
Use this to select how the oscillator pitch will be set.
FIXED:
With this setting, the oscillator pitch will stay at the same frequency regardless of the
note number.
RATIO:
With this setting, the frequency of the note number will be multiplied with the ratios set
in COARSE (Coarse Ratio) and FINE (Fine Ratio) to set the oscillator pitch.
TRANS (Transpose)
Shis the oscillator pitch in semitones over a range of ±1 octave. is setting is enabled only when
FREQ (Frequency Mode) is set to “RATIO”.
When “FREQ” is FIXED
x100, x1, x0.01
is sets the oscillator frequency over a range of 0.01 to 9999.99 Hz.
When “FREQ” is RATIO
COARSE (Coarse Ratio)
is is used for coarse adjustments of the oscillator pitch. When this setting is “1”, the frequency is
the same as the note number. When this setting is less than “1”, the pitch will shi down in units of
octaves. When this setting is more than “1”, the pitch will shi up in integer units according to the
frequency of the note number.