User's Manual

42
When “MODE” is set to RING (Ring Modulation)
is uses AM (amplitude modulation) to multiply the input signal from the modulator with the
oscillator.
DEPTH (Ring Depth)
Sets the balance between the ring modulator and oscillator signals. A setting of 100% outputs only
the ring modulator signal, and a setting of 0% outputs only the oscillator signal.
SHAPE
is is used to rectify the input signal from the modulator. A setting of 50% recties the waveform
halfway, and a setting of 100% produces a fully rectied waveform. e higher the value, the brighter
the tone will sound.
When “MODE” is set to FLTR (Filter)
Filters the input signal to cut out a specied tonal range. You can also mix in the oscillator sound for
output. e cuto frequency works in conjunction with the oscillator pitch.
TYPE (Filter Type)
Sets the type of lter used in the Operator.
OSCMIX (OSC Mix Level)
Sets the oscillator level inputted into the lter.
CUTOFF (Cutoff)
Although the lter cuto frequency works in conjunction with the oscillator pitch, you can use this
parameter to add an oset. is is set in semitones.
RESO (Resonance)
Emphasizes the frequencies around the cuto frequency.