User's Manual

41
OPERATORS: MODE
MODE: OP1...6 (Operator Mode)
MODE
Selects the Operator mode. (See “Operator modes”, p.7)
WAVE
is selects the waveform of the oscillator. (See “Waveform List”, p.77)
When “MODE” is set to FM (Frequency Modulation)
e pitch of an oscillator can be changed using the input signal from the modulator.
FB (Feedback)
Adjusts the amount of self-feedback from the Operator. When “WAVE” is set to “SIN”, the sound will
become brighter the closer that the feedback value gets to 75%, sounding more like a sawtooth wave.
When the feedback value exceeds 75%, the sound will become more like complex noise as the value
gets larger.
WIDTH (Wave Width)
is sets the width of the waveform that was congured using the “WAVE” parameter. You can
control the value using V.Patch to get distinctive sounds like those used in dance music.
OFF 50% 25%