User's Manual

Global: Page Menu Commands Half Damper Calibration
683
2. If you are unable to select this command from the
page menu, go to the main Global page as normal,
and then hold down the ENTER button and press
3 on the numeric keypad. This will call up the
calibration dialog.
3. Press the square in the upper left of the LCD.
When your touch has been detected correctly the
square will be highlighted.
4. Press the square in the lower right of the LCD.
When your touch has been detected correctly the
square will be highlighted.
5. Press the Done button.
If your touch was not detected correctly, an error
message will appear. Please perform the procedure
once again.
Half Damper Calibration
If a damper pedal that supports half damper (the DS–
1H option) is connected to the DAMPER jack, here’s
how you can adjust the sensitivity if the damper effect
is not applied appropriately.
Since the half-damper pedal is highly sensitive,
please use the optional DS–1H. Other pedals may
not produce the appropriate effect, or may be
impossible to calibrate correctly.
1. Connect a half-damper pedal to the DAMPER
jack.
2. Select “Half Damper Calibration” to open the
dialog box.
3. Press the half-damper pedal, and then release your
foot from the pedal.
4. Press the Done button.
If the adjustment could not be performed correctly,
an error message will be displayed. Please perform
the procedure once again.
Pad Calibration
This adjusts the velocity sensitivity of the pads.
1. Select “Pad Calibration” to open the dialog box.
2. Press the center of each pad as lightly as possible.
3. Press the Done button.
If the calibration could not be performed correctly, an
error message will appear. Please perform the
procedure again.
LCD Setup
This adjusts the color, contrast, and backlight
brightness of the LCD screen.
1. Choose LCD Setup to open the dialog box.
2. Adjust the parameters.
Contrast: 0…255 (64 is the default)
Adjusts the contrast of the LCD screen.
Brightness: 0…63 (63 is the default)
Adjusts the brightness of the display’s backlight.
Black Level: 0…255 (0 is the default)
Adjusts the black level of the LCD screen.
Color Temperature: User-RGB, 4200K, 5000K,
5400K, 6500K, 7500K, 9300K
Adjusts the color temperature of the LCD screen.
This will affect the hue.
User-RGB
These settings are used if you choose User-RGB for
Color Temperature.
R, G, B: Adjust each color in a range of –1024 –
+1023. (255 is default)
The specified color settings will be used if Color
Temperature = User-RGB.
3. Pressing the Reset button will reset the settings to
the default values.
4. To execute the LCD Setup, press the OK button. To
cancel, press the Cancel button.