User's Manual

Sequencer mode
512
inputs to the REC buses for sampling or resampling,
and set Source Bus (P0– Audio Input/Sampling 0–8c)
to REC1/2 or 3/4 so that these signals can be sampled.
Off: The signal will not be sent to a REC bus. Normally
you will leave this off.
1, 2, 3, 4: The output of the track will be sent to the
corresponding REC bus. The Pan setting (0–1b) of each
track will be ignored, and the signal will be sent in
monaural.
1/2, 3/4: The output of the track will be sent in stereo to
the corresponding pair of REC buses. The signal is sent
in stereo to REC buses 1/2 or 3/4 according to the Pan
setting (0–1b) of each track.
Track 02…16 (Track Number)
These settings specify the program oscillator output
bus, effect control bus, and REC bus used by MIDI
tracks 2 through 16. These are the same as for track 1.
See “Track 01”:.
▼ 8–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Memory Status. For more information, see
“Memory Status” on page 524.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy Insert Effect. For more information, see
“Copy Insert Effect” on page 149.
• 3: Swap Insert Effect. For more information, see
“Swap Insert Effect” on page 150.
• 4: Drum Kit IFX Patch. For more information, see
“Drum Kit IFX Patch” on page 410.
• 5: Put Effect Setting To Track. For more
information, see “Put Effect Setting to Track” on
page 557.
• 6: FF/REW Speed. For more information, see
“FF/REW Speed” on page 525.
• 7: Set Location (for Locate Key.) For more
information, see “Set Location (for Locate Key)” on
page 525.
8–3: Audio Routing1
Here you can specify the buses for the outputs of audio
tracks 1–16. You can also adjust the send amounts to
the master effects.
Audio tracks 1–16 can be processed by the insert
effects, master effects, and total effects, and routed to
the desired buses, in the same way as for MIDI tracks
1–16.
8–3a: Audio Routing1
Track 01 (Tack Number)
STEREO
This is shown if “Stereo Pair” is on.
1–1a
1–1b
8–1a
8–3a
8–3PMC