User's Manual

Combination P0: Play 0–9: Control Surface
345
LFO2 Speed. This scales LFO2’s frequency. When the
LFO is in MIDI/Tempo mode, this adjusts the Base
Note. For more information, please see “Frequency” on
page 84.
LFO2 Fade. This scales LFO2’s fade-in time. For more
information, please see “Fade” on page 85.
LFO2 Delay. This scales LFO2’s delay time - the time
between note-on and the onset of the LFO. For more
information, please see “Delay” on page 85.
LFO2 Stop. This Absolute parameter controls whether
LFO2 is stopped or running. For more information,
please see “Stop” on page 84.
Common LFO Speed. This scales the Common LFO’s
frequency. When the LFO is in MIDI/Tempo mode,
this adjusts the Base Note.
Unison. This Absolute parameter turns Unison on
and off. For more information, please see “Unison” on
page 34.
# Of Voices. This Absolute parameter sets the number
of Unison voices. If Unison is not On, this parameter
has no effect. For more information, please see
“Number of voices” on page 34.
Detune. This Absolute parameter sets amount of
detuning between the Unison voices. If Unison is not
On, this parameter has no effect. For more information,
please see “Detune” on page 34.
Thickness. This Absolute parameter sets the pattern of
detuning between the Unison voices. If Unison is not
On, or if Detune is set to 0, this parameter has no
effect. For more information, please see “Thickness” on
page 35.
▼ 0–9: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.
• 3: Copy Tone Adjust. This is available only when
Control Assign is set to TONE ADJUST. For more
information, see “Copy Tone Adjust” on page 407.
• 4: Reset Tone Adjust. This is available only when
Control Assign is set to TONE ADJUST. For more
information, see “Reset Tone Adjust” on page 407.
• 3: Copy Scene. This is available only when Control
Assign is set to RT KNOBS/KARMA. For more
information, see “Copy Scene” on page 147.
• 4: Swap Scene. This is available only when Control
Assign is set to RT KNOBS/KARMA. For more
information, see “Swap Scene” on page 147.