User's Manual

EXi: AL-1 Analog Synthesizer
208
8–2c: Frequency MIDI/Tempo Sync
MIDI/Tempo Sync [Off, On]
On (checked): When MIDI/Tempo Sync is On, the
LFO will synchronize to the system tempo, as set by
either the Tempo knob or MIDI Clock. The LFO speed
will be controlled by the Base Note and Multiply
parameters, below. All settings for Frequency and
Frequency Modulation will be ignored.
Off (unchecked): When MIDI/Tempo Sync is Off, the
Frequency settings will determine the speed of the
LFO, and the tempo settings will have no effect.
Base Note [ …  ]
This sets the basic speed of the LFO, relative to the
system tempo. The values range from a 32nd note to a
whole note, including triplets.
x (Multiply Base Note by…) [01…32]
This multiplies the length of the Base Note. For
instance, if the Base Note is set to a sixteenth note, and
Times is set to 3, the LFO will cycle over a dotted
eighth note.
▼ 8–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Program. For more information, see “Write
Program” on page 138.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy LFO. For more information, see “Copy
LFO” on page 212.
• 3: Swap LFO. For more information, see “Swap
LFO” on page 212.
8–3: LFO 2
The settings for LFO 2 are identical to those for LFO 1,
as described above.
8–4: LFO 3
The settings for LFO 3 are identical to those for LFO 1,
as described above.
8–5: LFO 4
The settings for LFO 4 are identical to those for LFO 1,
as described above.