User's Manual

Program mode: HD-1
98
Program P7: KARMA
This pages let you control the Program’s KARMA
settings. In Program mode, you can use one KARMA
Module (Module A).
Turning KARMA on and off
KARMA can be enabled or disabled for the current
Program by using the front-panel KARMA ON/OFF
switch. You can also temporarily disable KARMA for
all Programs, Combinations, and Songs by using the
Global All KARMA Off parameter. For more
information, see “All KARMA Off” on page 643.
Linking KARMA settings to Program changes
KARMA settings can be saved individually for each
Program. This includes all of the KARMA-related
front-panel buttons, sliders, and knobs, as well as the
on-screen parameters.
Normally, when you select a new Program, its
KARMA settings will be loaded as well. In some cases,
however, you may wish to try out different Programs
while keeping the KARMA settings the same.
The Global Basic page Load KARMA Settings when
changing parameters let you select between these two
behaviors. There are separate settings for Programs,
Combis, and Songs. To set this up:
1. Go to the Global Basic page.
2. Under “Load KARMA setting when changing”, set
the “Programs” check-box as desired.
Check the box to load the individual Programs’
KARMA settings.
Un-check the box to keep KARMA settings the same,
even when changing Programs.
For more information, see the Global parameter “Load
KARMA settings when changing” on page 643.
7–1: GE Setup/Key Zones
This page lets you select the GE used by the KARMA
Module, and set up the Key Zone in which it operates.
7–1a: Program Name, Load GE Options,
KARMA T.Sig, Tempo
Bank [INT–A…F, GM, g(1…9), g(d), USER–A…G]
Bank Type [HD-1, EXi]
Program [0…127 (INT and USER Banks),
1…128 (GM Banks)]
These are the current bank, bank type (HD-1 or EXi),
and Program. For more information, see “1–1a:
Program Name and Tempo” on page 32.
 (Tempo) [040.00…240.00, EXT]
This is the current Tempo. For more information, see
“1–1a: Program Name and Tempo” on page 32.
7–1PMC
7–1a