P.2 p.18 S.34 P.
Precautions Location Using the unit in the following locations can result in a malfunction. • In direct sunlight • Locations of extreme temperature or humidity • Excessively dusty or dirty locations • Locations of excessive vibration Power supply Please connect the designated AC adaptor to an AC outlet of the correct voltage. Do not connect it to an AC outlet of voltage other than that for which your unit is intended. Interference with other electrical devices This product contains a microcomputer.
Contents 1. Introduction 1. Introduction-------------------------------- 3 Thank you for purchasing the ToneWorks AX100G Modeling Signal Processor. Main features ------------------------------------------- 3 Front and rear panel ---------------------------------- 4 In order to enjoy your AX100G to the fullest, please read this manual carefully, and use the unit correctly.
1. Introduction ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Front and rear panel Front panel 8 WRITE, EXIT, TAP switches The WRITE switch is used to write an edited program. By pressing the EXIT switch, you can return to Program mode at any time. When using a delay effect, you can press the TAP switch at the tempo of the song to set the delay time automatically.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ The modes of the AX100G 2. Playing the AX100G The AX100G is divided into three modes: Program mode, Effect Select mode, and Phrase Trainer mode. Example connections The power must be off when making connections. Otherwise, damage to your speaker system, or other malfunctions may occur. Connecting cables are sold separately. Headphone (*1) 2.
2. Playing the AX100G ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Program mode When you turn on the power, the AX100G will always enter Program mode, and will be set to the program setting that were last selected when the power was turned off. When you once again press the TAP switch and EXIT switch simultaneously, the Bank Hold (10’S HOLD) function will be cancelled. Dot is lit Input level switch setting Set this switch according to the output of your instrument.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Press the RHYTHM switch (the LED will light) and the rhythm will begin playing. Use value knob 1 to select the rhythm pattern (50 types), use value knob 2 to adjust the tempo (range: 40—208), and use value knob 3 to adjust the rhythm level (range: 0—30). To stop the rhythm, press the RHYTHM switch while the rhythm is playing. The rhythm will stop when you enter Bypass, Mute, or Edit modes.
2. Playing the AX100G ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Phrase Trainer mode In this mode, you can record a phrase from an audio device (CD or MD) connected to the AUX IN jack, and play it back repeatedly as a loop. Then you can practice a phrase on your guitar while playing to the repeating phrase.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Editing the Drive Amp effect (example) In Program mode and Effect Select mode, you can edit each effect, adjust the noise reduction and program level, and modify the program name. During editing, the edit icons in the multi-display and the LEDs beside the select switches for each effect will blink. If you wish to save the effects you edited, you must use the "Program Write" operation.
3. Editing ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Using the TAP switch to edit the delay time Editing other effects Press the select switch for the desired effect to be edited. MOD: Edits the Modulation effect (e.g., chorus) PEDAL: Edits the Pedal effect (e.g., wah) AMB: Edits the Ambience effect (e.g.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 4. Appendices Restoring the user programs to the Adjusting the expression pedal factory settings (Reload) If you find the expression pedal difficult to use, perform this procedure so that the pedal will function optimally.
4. Appendices ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 6. Cannot write (the Multi-display indicates “ERROR”) Effect parameters ✳ Did you turn the power off while the preset programs were being loaded? Reload the preset programs. (☞p.11) DRIVE·AMP (Drive Amp effects) Knob 1 Knob 2 Knob 3 Knob 4 Knob 5 GAIN TREBLE MIDDLE BASS LEVEL — — — — — ACOUSTIC 0...10.0 0...10.0 0...10.0 0...10.0 0...10.0 CLASSIC COMP 0...10.0 0...10.0 0...10.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ US HI-GAIN (U.S. High Gain) “US HI-G” This model simulates the distortion typical of a high-gain amp made in the USA. WAH UP (Auto-wah filter up) This is an auto-wah filter that automatically opens or closes according to how hard you pick the strings. BRIT STACK (British amp stack) “BRITSTK” This model simulates the distortion typical of a British amp stack.
4. Appendices ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ PEDAL (Pedal effect) Knob 1 Knob 2 TYPE VOLUME Knob 3 Knob 4 Knob 5 DEPTH/PITCH MIX/LEVEL Pedal — 0...10.0 CHO1 0...10.0 — Depth CHO2 0...10.0 — Speed VIBRATE 0...10.0 — Speed FLANGER 0...10.0 — Modulation PHASER 0...10.0 — Speed TREMOLO 0...10.0 — Speed PAN 0...10.0 — Speed WAH — — Peak Fre. FILTER 0...10.0 — Peak Fre. RING 0...10.0 — Pitch PITCH -24...
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ GARAGE (Garage Reverb) This simulates the reverberation of a mid-size room such as a garage. The pedal will control the reverb level. HALL (Hall Reverb) This simulates the reverberation of a mid-size to large hall. The pedal will control the reverb level. Sample and play The SAMPLE1 to LOOP2 effects allow you to record a phrase up to 6 seconds, and then use the pedal to play it back.
4. Appendices ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ CABI (Cabinet effect) Knob 1 Knob 2 TYPE Knob 3 Rhythm Pattern List Knob 4 Knob 5 DEPTH Name No. Name 1×8 0...10.0 1 8BEAT1 26 DISCO 1×10 0...10.0 2 8BEAT2 27 EURO 1×12 0...10.0 2×12 0...10.0 3 8BEAT3 28 FUNK 4×10 0...10.0 4 8BEAT4 29 JAZZ1 4×12 0...10.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ Preset Program Parameter List When an effect that was off is turned on, the effect model printed in a slanted typeface will be selected. With the factory settings, the user programs have the same contents as the preset programs.
NOTICE KORG INC. 15 - 12, Shimotakaido 1 - chome, Suginami-ku, Tokyo, Japan. © 2000 KORG INC. E F G J 1 KORG products are manufactured under strict specifications and voltages required by each country. These products are warranted by the KORG distributor only in each country. Any KORG product not sold with a warranty card or carrying a serial number disqualifies the product from the manufacturer’s/distributor’s warranty and liability. This requirement is for your own protection and safety.
