User Manual

4
Front and rear panel
OUTPUT L/MONO, R jacks
Connect these to your powered
monitors, stereo amp, mixer, or
multi-track recorder.
If you want to use the microKORG
S in monaural, connect the
L/MONO jack.
HEADPHONES jacks
Connect a pair of
headphones to this jack
(1/4" stereo).
MIDI THRU connector
Received MIDI data is
re-transmitted without
change from this
connector. Use this when
you want to connect
multiple MIDI devices to
the same "stream" of
data.
MIDI OUT connector
This connector
transmits MIDI data.
MIDI IN connector
This connector receives
MIDI data.
MIDI
Use these connectors to connect the microKORG S to an external MIDI
device so that MIDI data can be exchanged.
MIC/LINE switch
If a mic is connected to the DYNAMIC
or CONDENSER jack, set this switch to
the MIC position. If an external
sequencer or audio device is connected,
set this switch to the LINE position.
VOLUME 1 knob
Adjusts the input level from the
DYNAMIC or CONDENSER jack.
CONDENSER jack
Connect a condenser mic to this jack.
DYNAMIC jack
Connect a dynamic mic, synthesizer, or
audio device to this jack.
If both the DYNAMIC jack and the
CONDENSER jack are connected, the
audio signal from the CONDENSER jack
will take priority.
AUDIO IN 1
A Synth program can use an audio signal from a synthesizer or external device
connected here as the oscillator 1 waveform.
A Vocoder program can use an audio signal from a mic etc. connected here as the
modulator audio.
VOLUME 2 knob
Adjusts the input level
from the LINE jack.
LINE jack
Connect a synthesizer
or audio device here.
AUDIO IN 2
A Synth program can use an audio signal from an
external device connected here as the oscillator 1
waveform.
A Vocoder program uses this input signal as the
external carrier for the vocoder.
Power switch
Switches the power on/off. (➝p.6)
AC adaptor jack
Connect the included AC adaptor to
this jack. After connecting the AC
adaptor to the microKORG S, plug
it into an AC outlet.
Grounding Screw
Use this screw to ground the unit.
To do so, loosen the screw and
attach a grounding wire. After
loosening the screw and attaching
the grounding wire to the unit, be
sure to tighten the screw. Do not use
the unit if the screw is removed.
Mic holder
You can attach the included
mic to this holder (➝p.5).
Rear panel