User Manual

47
21. GLOBAL
MASTER TUNE [30.0...50.0]
Adjusts the overall pitch in 0.1 Hz
steps over a range of 430.0 Hz to
450.0 Hz, in terms of A4 as the ref-
erence pitch. (The highest digit "4"
is not displayed.)
Use this when you need to tune the
pitch of the microKORG S to other
instruments.
MASTER TRANSPOSE [-12...12]
Adjusts the overall pitch in steps of
a semitone (100 cents) over a range
of one octave upward or down-
ward.
Use this when you wish to trans-
pose to suit the song you are play-
ing.
VELOCITY CURVE [Curve, 1...127]
Selects how velocity (keyboard
playing dynamics) will affect vol-
ume and tone.
Use the setting that is appropriate
for your situation.
Curve ( ):
The normal curve. (➝Figure 21-1)
1...127:
The fixed velocity you specify here
will be output regardless of how
strongly you play the keyboard.
SPEAKER [OFF, ON]
Specifies whether the audio will be
output from the built-in speakers.
OFF ( ):
built-in speaker is off.
ON ( ):
built-in speaker is on.
Depending on the volume and
program, the microKORG S may
vibrate or the sound may cause
vibrations. In that case, lower
the volume or listen to the sound
using headphones or an external
monitor.
AUDIO IN THRU [OFF, ON]
Specifies whether the signal input
from AUDIO IN will be output di-
rectly.
OFF ( ):
The signal will not be output.
ON ( ):
The signal will be output.
This setting will not be saved.
This setting is not memorized by
the Write operation. When the
power is turned on, it will al-
ways be turned OFF. While you
are editing, ORIGINAL VALUE
will always remain lit.
Strength
(MIDI Velocity)
ppp
MIN (1)
Velocity
MAX
(127)
fff
Curve (CrV)
(1) (127)
(64)
Figure 21-1
Here you can make overall settings for the microKORG S. "MASTER TUNE" (knob 1) and "MASTER TRANSPOSE" (knob 2) adjust the pitch.
"VELOCITY CURVE" (knob 3) specifies the velocity, "SPEAKER" (knob 4) specifies whether the microKORG S will play through the built-in
speakers, and "AUDIO IN THRU" (knob 5) specifies whether the input signal from AUDIO IN will be output directly.