Operation Manual

Reference • 12. Program mode
143
VDA Level modifies the VDA Level parameter (☞ P. 145) of both oscillators, adjusting the overall volume of
the entire program. Each step will change the parameter value 5 steps.
Velocity Sensitivity modifies the way in which changes in keyboard playing dynamics will affect the sound.
The EG Intensity parameter (☞ P. 154) for VDF Velocity Sensitivity and the VDA Velocity Sensitivity parame-
ter (☞ P. 160) for VDA Velocity Sensitivity will be modified for both oscillators. Each step will change the
parameter value 5 steps.
DRY:FX Balance modifies the Balance parameter between effects 1 and 2, adjusting the balance between the
“dry” sound of the program (unprocessed by the effect) and the “wet” sound processed by the effect. Each
step will change the parameter value 5 steps.
Page 2: Oscillator basic/Oscillator 2 relative
Here you can select the basic oscillator type: i.e., whether the program will use one or two oscillators, or a
drum kit. You can also specify whether the sound of the program will be maintained even after a Note-off
message is received, and whether the program will sound monophonically or polyphonically.
Oscillator type [SINGLE, DOUBLE, DRUMS]
This parameter determines the basic structure of the program.
SINGLE (single oscillator program) will cause the program to use only one oscillator. Maximum polyphony
will be 32 notes.
DOUBLE (double oscillator program) will cause the program to use two oscillators. This allows more com-
plex sounds to be created, but the maximum polyphony will be limited to 16 notes.
DRUMS (drum program) will assign a drum kit (instead of a multisample) to the program. (For details refer
to the explanation for the Multisample/Drum Kit parameter which follows later.)
Assign [MONO, POLY]
This specifies the number of simultaneous notes that the program will sound in response to Note messages
received on one MIDI channel.
MONO will cause the program to sound only one note at a time.
POLY will allow the program to play chords.
Oscillator type
Assign
Hold
OSC2 transpose
OSC2 delay
OSC2 detune