Owner's Manual

6
Mac OS users
Use the KORG AudioGate and USB Audio Device Setup program to install AudioGate.
If you're using AudioGate, it is not necessary to install the driver.
Installing the AudioGate
1
Access the following AudioGate 4 download page:
hp://www.korg.com/products/audio/audiogate4/download.php
2
Choose “AudioGate and USB Audio Device Setup Download,” and press the Mac ver-
sion of download buon to download the setup program.
3
Open the .dmg le. In the “KORG AudioGate and USB Audio Device Setup” folder,
run Setup. The KORG AudioGate and USB Audio Device Setup panel appears.
4
Click “Install AudioGate” in the KORG AudioGate and USB Audio Device Setup pan-
el.
Carefully read “Activating AudioGate” which appears during installation, and then
complete the installation.
5
Click “Finish” to exit the setup program.
If you’re recording with an application other than AudioGate, you’ll need to use the
“DS-DAC-10R Seing Tool” to set the input level. Click “Install the DS-DAC-10R Set-
ting Tool” to install it.