User Manual

13
Specifying layer pedals
IntheLayermode,adamperseingcanbespeciedfor
each sound.
Theseingsareonlyforthelayer1sound(o––),onlyfor
the layer 2 sound (– – o) and for both sounds (o – o).
Thedefaultseingiso–o.
1. Enter the Function mode, and then press the VIBES/
GUITAR buon.
The VIBES/GUITAR sound button lights up, and the
damperseing(o–o)appearsinthedisplay.
2. Select the damper seing with the UP or DOWN but-
ton beside the display.
2
2
1
If the sound is in the Single mode, – – – appears in the
display,andaseingcannotbespecied.
Specifying the auto power o󰀨 function
When 30 minutes have passed without a key pressed on
the keyboard or without an automatic performance played,
theinstrumentisautomaticallyturnedo.Todisablethis
function,turno(oFF)thisfunction.Thedefaultseingis
thisfunctionturnedon.Ifthisseingischanged,thenew
seingissavedandremainsselected,eveniftheLP-380is
turnedo.
1. Enter the Function mode, and then press the OR-
GAN1 buon.
TheORGAN1soundbuonlightsup,andtheseing
(on) appears in the display.
2. Select the on/o seing with the UP or DOWN but-
ton beside the display.
2
2
1
Specifying the volume balance for layers
The volume balance for sounds in the Layer mode (or the
Partnermode)canbeadjusted.Theseingrangeis1–9...
9 – 9...9 – 1, with the number on the left for layer 1 (or the
left side of the keyboard) and the number on the right for
layer 2 (or the right side of the keyboard).
Thedefaultseingis9–9.
1. Enter the Function mode, and then press the E.PIANO2
buon.
TheE.PIANO2soundbuonlightsup,andthebalance
seing(9–9)appearsinthedisplay.
2. Specify the volume balance setting with the UP or
DOWN buon beside the display.
To return to the default setting, simultaneously press
theUPandDOWNbuons.
2
2
1
If the sound is in the Single mode, – – – appears in the
display,andaseingcannotbespecied.
Specifying layer octaves
In the Layer mode, the octave for each sound can be speci-
ed.Theseingrangeis±1octaveforeachsound,and–01,
00and01appearinthedisplay.Thedefaultseingis00.
1. Enter the Function mode, and then press the HARP-
SI/CLAV buon.
The HARPSI/CLAV sound button lights up, and the
layer(L1)whoseoctaveistobespeciedappearsinthe
display.
2. Select the layer with the UP or DOWN buon beside
the display.
L1 appears for layer 1, and L2 appears for layer 2.
3. Press the BANK buon.
Theoctaveseing(00)appearsinthedisplay.
4. Select the octave seing with the UP or DOWN but-
ton beside the display.
To return to the default setting, simultaneously press
theUPandDOWNbuons.
To select the octave for the other layer, press the HARPSI/
CLAVbuontoselectthelayer.
2,4
1
3
2,4
If the sound is in the Single mode, – – – appears in the
display,andaseingcannotbespecied.