User Manual

Messages Error and confirmation messages
137
outside
□ Is the USB cable connected correctly? → p.26
The computer does not detect the KROSS
□ Are the USB cables connected correctly?
An error occurs when you disconnect from the computer
□ Never disconnect the KROSS from the computer while
your host application is in use.
While connected, you are asked to install software or a
device driver
□ Does the operating system or version of your computer
support the KROSS?
When using USB, sound processing is slow, or the tempo is
unstable
□ Is the KORG USB-MIDI driver installed correctly?
• You must install the dedicated Korg driver in order to
use the KROSS via USB MIDI.
If your computer’s operating system is Windows, you’ll
need to install the driver for each USB port where you
connect the KROSS.
If you connect the KROSS to a different USB port than
the one you used when installing the KORG USB-MIDI
Driver for Windows, you’ll need to reinstall the KORG
USB MIDI driver.
Your computer does not recognize an SD card that was
formatted by the KROSS
• Does the SD card reader support SDHC cards?
Messages
Error and confirmation messages
A
Aborted
Meaning: Execution of the function was cancelled.
Are you sure ?
Meaning: This message asks you to confirm execution. To
execute press the OK button. To cancel, press the CANCEL
button.
Audio recorder data error
Meaning: An error occurred while managing the audio song
recording data.
• No further recording is possible. Execute the Adjust
Audio Level function with “Level:00dB” on the recorded
data, and you’ll switch to a new audio song so that you
can continue recording.
Audio song full
Meaning: Another audio song cannot be created because
there are already 200 audio songs.
• Switch to a different SD card.
Auto Power-Off is enabled.
The system will automatically shut down after being idle
for 30 minutes/1 hour/4 hours.
Meaning: The auto power-off function is enabled. If the
KROSS has not been played or operated for a specified
length of time, the power will turn off automatically.
• If you want to disable this function or change the time
setting, go to the GLOBAL> PREF 1 page and set the
Auto Power-Off parameter. Use the Write Global Setting
function to save the setting.
C
Can’t calibrate
Meaning: Calibration could not be performed correctly.
•Try again.
Can’t update system
Meaning: Execution of the Update System Software
operation did not end successfully.
• Try the operation again.
Completed
Meaning: The processing executed by the command has
been completed.
Completed. Please turn the power off, and then on again.
Meaning: Execution of Update System Software has been
completed successfully. Turn the power switch off, and then
on again to complete the update.