User Manual

Appendices
118
T
There is no readable data
Meaning: Either the file size is 0 or the file does not contain
data that can be accessed by the load or open procedure.
Alternatively, the data is damaged etc., and cannot be loaded
or accessed.
The song exists, and will be initialized
Meaning: When executing the Sequencer mode Create New
Song function, you attempted to create a new song for a song
number that already exists. If you execute, the song will be
initialized, and a new song will be created and overwritten
onto it.
• If you don’t want to initialize the currently-existing song,
specify a new song number.
The system has been idle for more than **** and will shut
down in:
You can change the Auto Power-Off setting on the
following page: GLOBAL - PREF
Meaning: If there has been no operation for the specified
length of time of time, the Auto Power Off function will
display a message informing you that the power will turn off
soon. The power will turn off when the countdown time
indication reaches zero.
• If you want to continue using the KROSS, press a key or
switch. Auto Power Off will be reset, and the same
message will appear when the specified length of time
has once again elapsed without any operation.
• If you want to disable this function or change the time
setting, go to the GLOB> PREF page and set the Auto
Power-Off parameter. Use the Write Global Setting
function to save the setting.
Y
You can’t undo last operation. Are you sure?
Meaning: Once you enter event editing (even if you leave
event editing without actually editing an event), it will no
longer be possible to execute Compare to listen to the
previous edit. If you wish to enter event editing, press the
OK button. To cancel, press the CANCEL button.
You can’t undo this operation. Are you sure?
Meaning: When you exit recording or event editing in
Sequencer mode, the memory area for Undo (Compare
function) is not allocated. If you wish to keep the data that
was just recorded or edited, press the OK button. If you wish
to return to the previous data (i.e., to delete the data that was
just recorded or edited), press the CANCEL button.
Meaning: When editing in Sequencer mode, memory area
for Undo (Compare function) cannot be allocated. If you
wish to execute the edit, press the OK button (It will not be
possible to undo your edit). If you decide not to execute the
edit, press the CANCEL button.
• In order to allocate memory area for Undo (Compare
function), delete unneeded data such as songs, or tracks.
We recommend that you data to media before you
execute the edit procedure.
You can use “Quick Setting” with [EXIT]+[AUDIO IN]
Meaning: This is shown at the bottom of the screen in the
Audio In page of a program, combination, or song if the G-
SET check box is selected. In this case, the Audio In settings
will use the Global mode> G-INPUT/CTRL> AUDIO IN
page settings. You can hold down the EXIT button and press
the AUDIO IN button to access the Audio In - Quick Setting
dialog box to make settings easily.