User Manual

MIDI recording Recording patterns
101
recording. If you continue recording, the newly recorded
data will be added to the previously-recorded data.
9. If you want to delete specific data while you continue
pattern recording, you can press the SEQUENCER
REC/WRITE switch or check the “Remove Data”
check box.
For details refer to step 6 of “Loop All Tracks” on
page 93.
10.Press the SEQUENCER START/STOP switch to stop
recording.
If you made a mistake or decide to re-record, press the
SEQUENCER START/STOP switch to stop recording,
and press the COMPARE switch. Then begin the pattern
recording procedure again as in step 8.
Control data in pattern recording
To record control data in a pattern, you should restore the
control data to its normal value within the pattern. If you fail
to restore the normal value, unnecessary control data may
remain in a “stuck” position when you place the pattern in a
song or use the RPPR function to play the pattern. However,
the following control data will be automatically reset to the
following values when the song or RPPR function finishes
playing the pattern, or when playback is halted.
Using KARMA for pattern recording
If KARMA is set to operate for the track that is selected for
“Track Select,” and record the performance of KARMA into
the pattern.
Pattern Select
Controller Reset value
Modulation 1 (CC#01) 00 (zero)
Modulation 2 (CC#02) 00 (zero)
Expression (CC#11) 127 (max)
Ribbon controller (CC#16) 64 (center)
Damper switch (CC#64) 00 (zero)
Sostenuto switch (CC#66) 00 (zero)
Soft switch (CC#67) 00 (zero)
EG sustain level (CC#70) 64 (center)
Resonance level (CC#71) 64 (center)
EG release time (CC#72) 64 (center)
EG attack time (CC#73) 64 (center)
Low pass filter cutoff (CC#74) 64 (center)
EG decay time (CC#75) 64 (center)
LFO1 speed (CC#76) 64 (center)
LFO1 depth (pitch) (CC#77) 64 (center)
LFO1 delay (CC#78) 64 (center)
Filter EG intensity (CC#79) 64 (center)
SW1 modulation (CC#80) 00 (zero)
SW2 modulation (CC#81) 00 (zero)
Channel after touch 00 (zero)
Pitch bender 00 (zero)
Controller Reset value