User Manual
Table Of Contents
- About this manual
- Contents
- Introduction to KRONOS
- Front and rear panels
- Front panel
- 1. MAIN VOLUME knob
- 2. Control Surface
- 3. Data entry
- 4. DISK access indicator
- 5. MODE buttons
- 6. UTILITY buttons
- 7. BANK SELECT buttons
- 8. KARMA buttons
- 9. Vector Joystick
- 10. Drum Track
- 11. SW1 and SW2
- 12. Joystick
- 13. Ribbon controller
- 14. Headphone jack
- 15. EXIT button
- 16. SEQUENCER buttons
- 17. TEMPO controls
- 18. SAMPLING buttons
- 19. TouchView display
- Rear panel
- TouchView user interface
- Front panel
- Basic information
- Setup
- Update information
- Front and rear panels
- Playing and editing Programs
- Playing and editing Combinations
- Playing Combinations
- Easy Combination editing
- Detailed Combination editing
- Creating songs (Sequencer mode)
- Set Lists
- Sampling (Open Sampling System)
- Global Settings, Wave Seq., Drum Kits
- Loading & saving data, and creating CDs
- Using Effects
- Using KARMA
- Using the Drum Track
- Appendices
- Troubleshooting
- Error and confirmation messages
- A (ADC–Are You Sure)
- B (Buffer)
- C (Can’t calibrate–Completed)
- D (Destination–Disk)
- E (Error–Exceeded)
- F (File–Front)
- H
- I (Illegal–Index)
- K
- M (Master–Multisample)
- N (No data–Not enough song memory)
- O (Obey copyright rules–Oscillator)
- P (Pattern–Program)
- R (Rear sample–Root)
- S (Sample–Source)
- T (The clock–/TEMP folder detected)
- U (Unable to create directory–USB Hub)
- W (Wave)
- Y (You)
- Disk and Media information
- Specifications
- MIDI Implementation Chart
Appendices
286
General Disk Mode Load, save, utility, audio CD burning, audio CD playback, data filer function (save/load MIDI System
Exclusive data), CD-R/RW (UDF format read/write), ISO9660 Level 1
Controllers Vector joystick, joystick, ribbon controller, switches 1 & 2
Control Surface Control Assign Switches: Assigns the Control Surface to Timber/Track, Audio,
External, Realtime Knobs/KARMA, Tone Adjust/EQ
Mixer Knobs Switch: Assigns the Mixer Knobs to either Channel Strip or
Individual Pan, Reset Control Switch, Solo Switch, Knobs 1-8, Switches 1-8
(Upper Row), Switches 1-8 (Lower Row), Sliders 1-8, Master Slider
KARMA Control: On/Off, Latch, Module Control
KARMA Controller
Section
Switches = ON/OFF, LATCH, MODULE CONTROL
DRUM TRACK
Controller Section
Switches = ON/OFF
Display TouchView graphical user interface, 8 inch TFT, SVGA (800x600 dots), adjustable brightness.
Principal specifications Frequency response 20 Hz–22 kHz ±1.0 dB, 10 k
load
THD+N 20 Hz–22 kHz 0.01%, 10 k load (typical)
Signal to noise ratio 95 dB (typical)
Dynamic range 95 dB (typical)
Crosstalk 95 dB, at 1 kHz (typical)
Audio Outputs (Analog)
(Digital)
AUDIO OUTPUT
(MAIN) L/MONO, R
AUDIO OUTPUT
(INDIVIDUAL) 1–4
1/4” TRS balanced
Output Impedance: 350
stereo; 175 mono (L/Mono only)
Nominal Level: +4.0 dBu
Maximum Level: +16.0 dBu
Load Impedance: 600
or greater
MAIN VOLUME knob controls only AUDIO OUTPUT (MAIN) L/MONO and R
Headphones 1/4” stereo phone jack
Output Impedance: 33
Maximum Level: 60+60 mW @33
MAIN VOLUME knob (link with AUDIO OUTPUT (MAIN))
Optical S/P DIF Format: 24 bit, S/P DIF IEC60958 EIAJCP-1201
Sample Rate: 48 kHz
Digital output of the same signals as AUDIO OUTPUT (MAIN) L/MONO and R
USB B Format: 24 bit
Sample Rate: 48 kHz
2 channels (Digital output of the same signals as AUDIO OUTPUT (MAIN)
L/MONO and R)
Audio Inputs (Analog)
(Digital)
Audio inputs 1, 2 1/4” TRS balanced
MIC/LINE input level switches, LEVEL knobs
Input Impedance: 10 k
Nominal Level: LINE
+4 dBu (LEVEL knob = min), –36 dBu (LEVEL knob = max)
Nominal Level: MIC
–22 dBu (LEVEL knob = min), –62 dBu (LEVEL knob = max)
Maximum Level: LINE
+16 dBu (LEVEL knob = min), –24 dBu (LEVEL knob = max)
Maximum Level: MIC
–10 dBu (LEVEL knob = min), –50 dBu (LEVEL knob = max)
Source Impedance: 600
Signal to noise ratio: 95 dB (typical)
Dynamic range: 95 dB (typical)
Crosstalk: 95 dB, at 1 kHz (typical)
Optical S/P DIF Format: 24 bit, S/P DIF IEC60958 EIAJCP-1201
Sample Rate: 48 kHz
USB B Format: 24 bit
Sample Rate: 48 kHz
2 channels
Control Inputs DAMPER (half damper supported)
ASSIGNABLE SWITCH, ASSIGNABLE PEDAL
MIDI IN, OUT, THRU
USB USB A (TYPE A) x 2 For connection to QWERTY keyboards, MIDI controllers, ethernet adaptors,
and storage devices
USB B (TYPE B) x 1 MIDI/audio interface
MIDI: 1 (16 channel) input / 1 (16 channel) output
Audio: 2 channel input / 2 channel output
2 USB 2.0 High-Speed ports (supports 480 Mbps)
Disk Drive 60 GB SSD (2.5”); optional installation of second internal SSD
Power AC Power Supply terminal, POWER On/Off switch