User Manual
Table Of Contents
- About this manual
- Contents
- Introduction to KRONOS
- Front and rear panels
- Front panel
- 1. MAIN VOLUME knob
- 2. Control Surface
- 3. Data entry
- 4. DISK access indicator
- 5. MODE buttons
- 6. UTILITY buttons
- 7. BANK SELECT buttons
- 8. KARMA buttons
- 9. Vector Joystick
- 10. Drum Track
- 11. SW1 and SW2
- 12. Joystick
- 13. Ribbon controller
- 14. Headphone jack
- 15. EXIT button
- 16. SEQUENCER buttons
- 17. TEMPO controls
- 18. SAMPLING buttons
- 19. TouchView display
- Rear panel
- TouchView user interface
- Front panel
- Basic information
- Setup
- Update information
- Front and rear panels
- Playing and editing Programs
- Playing and editing Combinations
- Playing Combinations
- Easy Combination editing
- Detailed Combination editing
- Creating songs (Sequencer mode)
- Set Lists
- Sampling (Open Sampling System)
- Global Settings, Wave Seq., Drum Kits
- Loading & saving data, and creating CDs
- Using Effects
- Using KARMA
- Using the Drum Track
- Appendices
- Troubleshooting
- Error and confirmation messages
- A (ADC–Are You Sure)
- B (Buffer)
- C (Can’t calibrate–Completed)
- D (Destination–Disk)
- E (Error–Exceeded)
- F (File–Front)
- H
- I (Illegal–Index)
- K
- M (Master–Multisample)
- N (No data–Not enough song memory)
- O (Obey copyright rules–Oscillator)
- P (Pattern–Program)
- R (Rear sample–Root)
- S (Sample–Source)
- T (The clock–/TEMP folder detected)
- U (Unable to create directory–USB Hub)
- W (Wave)
- Y (You)
- Disk and Media information
- Specifications
- MIDI Implementation Chart
Using KARMA
234
If you turn “Solo” On (checked), only that KARMA module
will sound. This is useful when you are selecting a GE, or
when you want to audition the phrase that a module is
generating.
Modules whose “Solo” is On (checked) will sound even if
“Run” is Off (unchecked).
The “Solo” setting is cleared when you switch to another
combination. It is not saved when you write the
combination.
KARMA module A will sound.
KARMA module B will sound.
KARMA modules A and B will sound.
Note: If “ ” is not shown in the display, “Run” has
been assigned as a performance realtime performance. The
KARMA SWITCHES etc. will control “RUN.”
KARMA module MIDI I/O channel
settings
The MIDI input/output channel setting for each KARMA
module and the MIDI channel setting of each timbre
together determine how the KARMA modules will play the
timbres.
If a KARMA module’s MIDI output channel matches the
MIDI channel of a timbre, the phrase or pattern generated by
that KARMA module (if it’s operating) will play that timbre.
For details on making these settings, see “Editing KARMA
in Combination mode” on page 239 and “7–1c: MIDI I/O”
on page 475 of the Parameter Guide.
GE (Generated Effect) selection
Just as for a program, you can use the “GE Select” field to
select the GE used by each module. (See “Editing KARMA
in Combination mode” on page 239)
KARMA module parameter settings
For details on editing KARMA module parameters, see
“Editing KARMA in Combination mode” on page 239.