User Manual
Table Of Contents
- About this manual
- Contents
- Introduction to KRONOS
- Front and rear panels
- Front panel
- 1. MAIN VOLUME knob
- 2. Control Surface
- 3. Data entry
- 4. DISK access indicator
- 5. MODE buttons
- 6. UTILITY buttons
- 7. BANK SELECT buttons
- 8. KARMA buttons
- 9. Vector Joystick
- 10. Drum Track
- 11. SW1 and SW2
- 12. Joystick
- 13. Ribbon controller
- 14. Headphone jack
- 15. EXIT button
- 16. SEQUENCER buttons
- 17. TEMPO controls
- 18. SAMPLING buttons
- 19. TouchView display
- Rear panel
- TouchView user interface
- Front panel
- Basic information
- Setup
- Update information
- Front and rear panels
- Playing and editing Programs
- Playing and editing Combinations
- Playing Combinations
- Easy Combination editing
- Detailed Combination editing
- Creating songs (Sequencer mode)
- Set Lists
- Sampling (Open Sampling System)
- Global Settings, Wave Seq., Drum Kits
- Loading & saving data, and creating CDs
- Using Effects
- Using KARMA
- Using the Drum Track
- Appendices
- Troubleshooting
- Error and confirmation messages
- A (ADC–Are You Sure)
- B (Buffer)
- C (Can’t calibrate–Completed)
- D (Destination–Disk)
- E (Error–Exceeded)
- F (File–Front)
- H
- I (Illegal–Index)
- K
- M (Master–Multisample)
- N (No data–Not enough song memory)
- O (Obey copyright rules–Oscillator)
- P (Pattern–Program)
- R (Rear sample–Root)
- S (Sample–Source)
- T (The clock–/TEMP folder detected)
- U (Unable to create directory–USB Hub)
- W (Wave)
- Y (You)
- Disk and Media information
- Specifications
- MIDI Implementation Chart
Other disk operations Setting the date and time
209
Other disk operations
Setting the date and time
KRONOS has an internal calendar, which is used to record
the date and time when you save data. You can set the date
and time by using the Disk Utility page’s Set Date/Time
menu command.
You will need make these settings after you purchase the
KRONOS, and after replacing the calendar backup battery.
1. Press the DISK button to enter Disk mode.
2. Select the Disk–Utility page. Press the File tab, and
then the Utility tab.
3. Open the page menu, and select the Set Date/Time
command.
The following dialog box will appear.
4. Use the VALUE controllers to set the correct year,
month, day, hour, minute, and second.
5. Press the OK button.
If the calendar backup battery runs low, the following
message will appear in the LCD screen:
“The clock battery voltage is low. Please replace the
battery, and set the date and time in Disk mode”
If the calendar backup battery runs down completely, the
calendar will be initialized, and the date and time will not
be recorded correctly. Your Korg Distributor can help you
find a service center to replace the battery.