User Manual
Table Of Contents
- About this manual
- Contents
- Introduction to KRONOS
- Front and rear panels
- Front panel
- 1. MAIN VOLUME knob
- 2. Control Surface
- 3. Data entry
- 4. DISK access indicator
- 5. MODE buttons
- 6. UTILITY buttons
- 7. BANK SELECT buttons
- 8. KARMA buttons
- 9. Vector Joystick
- 10. Drum Track
- 11. SW1 and SW2
- 12. Joystick
- 13. Ribbon controller
- 14. Headphone jack
- 15. EXIT button
- 16. SEQUENCER buttons
- 17. TEMPO controls
- 18. SAMPLING buttons
- 19. TouchView display
- Rear panel
- TouchView user interface
- Front panel
- Basic information
- Setup
- Update information
- Front and rear panels
- Playing and editing Programs
- Playing and editing Combinations
- Playing Combinations
- Easy Combination editing
- Detailed Combination editing
- Creating songs (Sequencer mode)
- Set Lists
- Sampling (Open Sampling System)
- Global Settings, Wave Seq., Drum Kits
- Loading & saving data, and creating CDs
- Using Effects
- Using KARMA
- Using the Drum Track
- Appendices
- Troubleshooting
- Error and confirmation messages
- A (ADC–Are You Sure)
- B (Buffer)
- C (Can’t calibrate–Completed)
- D (Destination–Disk)
- E (Error–Exceeded)
- F (File–Front)
- H
- I (Illegal–Index)
- K
- M (Master–Multisample)
- N (No data–Not enough song memory)
- O (Obey copyright rules–Oscillator)
- P (Pattern–Program)
- R (Rear sample–Root)
- S (Sample–Source)
- T (The clock–/TEMP folder detected)
- U (Unable to create directory–USB Hub)
- W (Wave)
- Y (You)
- Disk and Media information
- Specifications
- MIDI Implementation Chart
Preparations for sampling Audio Settings
137
In Sequencer mode, you can select any of the above, plus the
Sequencer START SW.
For the trigger mode that’s most appropriate in various
situations, refer to the various examples of sampling later in
this chapter.
Sampling START SW: When you press the SAMPLING
REC, you will enter sampling-standby mode; sampling will
begin when you press the SAMPLING START/STOP
switch.
Note On: Press the SAMPLING REC switch and then press
the SAMPLING START/STOP switch to enter sampling-
standby mode. Sampling will begin when you play the
keyboard.
Threshold: Sampling will begin automatically when the
input level exceeds the specified Level value.
Sequencer START SW: Press the SAMPLING REC switch
and then the SAMPLING START/STOP switch to enter
sampling-standby mode. Then press the SEQUENCER
START/STOP switch to begin sampling. Use this when you
want to resample the song playback.
To stop sampling, press the SAMPLING START/STOP
switch once again. Sampling will also end if you keep
sampling until the time specified by “Sample Time.”
Making settings for the sample to be
recorded
(REC Sample Setup/Sampling Setup)
Next we will specify the location into which the data will be
sampled, select mono or stereo sampling, and specify the
sampling time.
In Sampling mode, these settings are made in REC Sample
Setup. In Combination, Program, and Sequencer modes,
these settings are made in Sampling Setup. These settings
apply only in each respective mode.
The Recording Setup page in each mode
Sampling mode
Recording Level [dB]
Metronome Setup
Input
Sampling Setup
Mode Page
Sampling Sampling P0– Recording
Combination Combination P0– Audio Input/Sampling
Program Program P0– Audio Input/Sampling
Sequencer Sequencer P0– Audio Input/Sampling
Save to
Mode
Sample Time
Free Sample
Memory /
Free Number