User Manual
Table Of Contents
- About this manual
- Contents
- Introduction to KRONOS
- Front and rear panels
- Front panel
- 1. MAIN VOLUME knob
- 2. Control Surface
- 3. Data entry
- 4. DISK access indicator
- 5. MODE buttons
- 6. UTILITY buttons
- 7. BANK SELECT buttons
- 8. KARMA buttons
- 9. Vector Joystick
- 10. Drum Track
- 11. SW1 and SW2
- 12. Joystick
- 13. Ribbon controller
- 14. Headphone jack
- 15. EXIT button
- 16. SEQUENCER buttons
- 17. TEMPO controls
- 18. SAMPLING buttons
- 19. TouchView display
- Rear panel
- TouchView user interface
- Front panel
- Basic information
- Setup
- Update information
- Front and rear panels
- Playing and editing Programs
- Playing and editing Combinations
- Playing Combinations
- Easy Combination editing
- Detailed Combination editing
- Creating songs (Sequencer mode)
- Set Lists
- Sampling (Open Sampling System)
- Global Settings, Wave Seq., Drum Kits
- Loading & saving data, and creating CDs
- Using Effects
- Using KARMA
- Using the Drum Track
- Appendices
- Troubleshooting
- Error and confirmation messages
- A (ADC–Are You Sure)
- B (Buffer)
- C (Can’t calibrate–Completed)
- D (Destination–Disk)
- E (Error–Exceeded)
- F (File–Front)
- H
- I (Illegal–Index)
- K
- M (Master–Multisample)
- N (No data–Not enough song memory)
- O (Obey copyright rules–Oscillator)
- P (Pattern–Program)
- R (Rear sample–Root)
- S (Sample–Source)
- T (The clock–/TEMP folder detected)
- U (Unable to create directory–USB Hub)
- W (Wave)
- Y (You)
- Disk and Media information
- Specifications
- MIDI Implementation Chart
Audio recording Recording procedure
101
Connect your guitar
1. Connect your guitar to the rear panel AUDIO INPUT
1 jack.
Press the AUDIO INPUT MIC/LINE switch inward to
select the LINE position, and set the LEVEL knob at
about the center.
If you connect a guitar with passive pickups (i.e., a guitar
that does not contain a preamp), you will be unable to
sample it at the correct level because of the impedance
mismatch. Such guitars should be routed through a
preamp or an effect unit first, and then connected to the
KRONOS.
Setup
2. In the P0: Play/REC– Audio Input Sampling page, set
the Audio Input parameters as described below.
Use Global setting Off
– INPUT 1 –
Bus Select (IFX/Indiv.): Off
Pan: L000
Level: 127
REC Bus: Off
Note: the meter to the left of the Level fader shows the
signal level immediately after A/D conversion, before the
Level control. Changing the Level will not affect the
meter.
In the P0: Play/REC– Audio Track Mixer page, use REC
Source to select Audio Input 1 (In 1), so that the signal
from Audio Input 1 will be recorded directly on audio
track 1.
Audio Track 1 REC Source: Audio Input 1 (In 1)
Go to the P8: Insert Effect– Audio Routing1 page.
Set the output for Audio Track 1 as follows.
Bus Select (IFX/Indiv. Out Assign): L/R
Send1 (MFX1) and Send2 (MFX2): 000
3. In the P0: Play/REC– Preference page, set “Track
Select” to Audio Track 01.
LINE
Guitar
Eect unit