User's Manual

CONTROL BUTTONS
5
Button Description :
1. : Display On Screen Control menu.
Select Control menu.
2. : Move selected icon up to select one of the controls.
Increase the control value.
3. : Move selected icon down to select one of the controls.
Decrease the control value.
4. : Exits the On Screen Control.
Do Auto In Progress function. (Press and hold this button for two
seconds.)
AUTO
R
AUTO
R
AUTO
R
AUTO
R
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTEDGETTING STARTED
INSTALLATION
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTED
GETTING STARTEDGETTING STARTED
4
◆ Follow these steps to install the monitor
1. Before you connect the cables, make sure the monitor and system
unit power switches are OFF.
2. Plug one end of the 15-pin signal cable to the rear of your system.
The adapter may be required for certain Apple Macintosh
computers. Tighten the two screws on the cable connector.
3. Connect the power cord to the inlet socket which is located at the
rear of the display. Connect the plug into an AC wall outlet.
(fig. 1)
POWER SWITCH
OSD SWITCH