User's Manual

INSTALLATION

GETTING STARTED

◆ Follow these steps to install the monitor

1. Before you connect the cables, make sure the monitor and system

unit power switches turn off.

2. Plug the 15-pin D-SUB, 24-pin DVI(KL1722B,BM) signal cable between

the rear of your Monitor and system. The adapter may be required for

certain Apple Macintosh computers. Tighten the two screws on the cable

connector.

3. Plug the Audio Cable between Audio input Jack in the rear of your

monitor and audio output of your system.(KL1722AM,BM)

4. Connect the power cord to the inlet socket which is located at the

AC Adapter. Connect the plug into an AC wall outlet.

5. Connect DC Plug of AC Adapter to the DC jack which is located at the

rear of your monitor