User's Manual

BIOS Configuration 4-49
CAPTUER 4
This section explains how to install an expansion card in your computer. Your
computer has three 32-bit PCI and one AMR connectors.
Follow the below steps to install an expansion card.
1. Remove the system cover according to the instructions in "Removing the Cover"
in Chapter 5.
2. Insert a flat blade screwdriver into a hole of the slot cover you wish to remove.
3. Move the screwdriver up and down until the slot cover breaks away from the
chassis. Then lift
the slot cover out of the chassis
4. If there is any switches or jumpers on the expansion card, adjust them. When you
handle the card, be careful not to touch any components or the gold edged
connector.
Push the expansion card connector in firmly to the connector on the mainboard. The
expansion
5. card connector must be fully inserted in the connector on the mainboard.