User's Manual

CAPTUER 3
3-4 Using Your Computer
If you want to remove the CD/CDRW/DVD title, make you sure that the busy
indicator is off. Press load/eject button, and then remove CD/CDRW/DVD title
when the disk tray pops out. Press load/eject button again to close the tray.
Using a CDRW/COMBO Drive
To use CD/CDRW/DVD ROM drive, turn on your system and then press the load/
eject button. (CDRW drive does not recognize DVD title.)
When the disk tray pops out, put CD/CDRW/DVD title in the tray with the label side
up. Press the load/eject button again or gently push the disk tray to close it. During
the procedure, the busy indicator will flash.
NOTES
When your system is turned off, you may need to open the CDRW/COMBO tray.
At this time, insert a fine rod such as an opened paper clip into the emergency eject
hole as far as it will go. When the tray is slightly open, carefully pull it out.