User's Manual

Installing and Removing Board Options and Drives 6-13
CHAPTER 6
6. Make you sure that jumpers of optional drive must be set correctly.
NOTE
As a hard disk drive, most optional devices’ jumpers must be set correctly to work
properly with your system. For example, if there are two drives to one E-IDE
interface cable, one drive must have master drive jumper setting, and the other
drive must have slave drive jumper setting.
If you want to install an optional drive to the 5.25 inch bay, you must use
secondary E-IDE drive connector. If your CD/DVD ROM is set to master, the
optional drive’s jumper must be set to slave.
7. Slide the device into the bay and secure it to the computer case with four screws.
8. Connect the power and interface cables to the device installed.