User's Manual

CHAPTER 6
6-10 Installing and Removing Board Options and Drives
7. Slide the drive until the four slots in the HDD bracket are inserted into the four
tabs of the chassis and then secure the HDD brakcet with the retaining screw, as
shown below.
5. Set the jumper of the new hard disk drive. If you want to install only hard disk
drive, the jumper setting must be master drive.
6. Using the screws, secure the hard disk drive to the HDD bracket.
8. Connect the free power cable and hard disk drive cable to the hard disk drive.
9. If you removed the hard disk drive cable from the mainboard, replace it.
10. Replace the system cover according to the instructions in "Replacing the Cover"
in Chapter 5.