User's Manual

CHAPTER 6
6-4 Installing and Removing Board Options and Drives
Installing and Removing Memory Modules
Your computer may have come with one memory module inserted into the
mainboard.
You can add a DIMM with the capacity of 16MB, 32MB, 64MB, or 128MB. You
can increase the amount of memory in your computer up to 256MB.
Each DIMM socket supports the following memory features:
● Unbuffered 168-pin 3.3 V DIMMs with gold-plated contacts
● SDRAM
● Single or double-sided DIMMs in the following sizes:
Installing a Memory Module
Follow the below steps to install DIMMs.
1. Remove the cover according to the instructions in "Removing the Cover" in
Chapter 5.
2. Install the DIMM in the socket marked with DIMM2, if the DIMM is installed in
the DIMM1 socket.
Press the clips at each end of the socket outward until they snap open.
3. Orient a DIMM to the socket so the two notches in the DIMM connector are
aligned with the crossbars in the socket.
DIMM size Non-ECC memory
16MB 2 Mbit * 64bit
32MB 4 Mbit * 64bit
64MB 8 Mbit * 64bit
128MB 16 Mbit * 64bit
256MB 32 Mbit * 64bit
512MB 64 Mbit * 64bit