User manual

38
Commissioning - test sequence
ThePRCD-Smustfundamentallybecheckedasfollowsbe-
foreeveryuse:
• Plugthemainsplugintoexistingoutlet
• Activatethe“I-ON”button
7
with bare hands
• Redglowlamp
8
illuminates - PRCD-S is switched on and
 readyforuse.
• Activate “O-Test” button
9
, residual current device is
created.
• PRCD-Sswitcheso.
• Redglowlampswitcheso.
IfthePRCD-SdoesnotactivatebymeansoftheO-Testbut-
ton,the device must immediatelybe disconnected from
the mains and checked.
After the PRCD-S is switched on again, the connected
device must be able to be operated.
Otherwise,Table1aidsintroubleshooting.
Caution
ThePRCD-Sortheentireconnectionset,respectively,must
besubjectedtoaregularrepeattest.
BeforeopeningthePRCD-S,themains plugmust always
be unplugged!
Regulations and rules
ThePRCD-SwasdevelopedbasedonDINVDE0661Port-
able protective devices intended for an increase in the pro-
tection level for a rated voltage U
n
=230V,ratedcurrentIn
≤16A,ratedresidualcurrentI
ΔN
≤30mA).
Theemployer‘sliabilityinsurance associations(BG ETEM
(Energie Textil Elektro) among others) recommend the
PRCD-S as an eective protective measure for connecting
portable consumers to outlets of unknown protection
(unknownprotectivedevice)intheirguidelines(BGI608/
DGUVinformation203-006).
