Use and Care Manual
Table Of Contents
7
o The shelves are fully adjustable to suit various wine bottle shapes and sizes.
o To prevent damaging the door gasket, make sure the door is fully open when pulling shelves
out of the rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves are
designed with an emergency stop to prevent them being removed too far when loaded.
Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information
contained in the installation instructions.
o After delivery, wait for eight hours before connecting the appliance to your mains supply. This
will allow any refrigerant gasses that may have been disturbed during the transportation process
to settle.
o The outside of the appliance and the removable accessories contained within it, should be
cleaned with a solution of liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved
in lukewarm water.
The interior and accessories should be thoroughly dried, after the cleaning process has been
completed.
o There can be an odor when you first switch on the appliance. It will lessen as the appliance
starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it
has been turned off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED display. This is normal and it is due
to the length of activation time. Once the wine cooler has been running for a few hours
everything will be back to normal.
o When you first switch on the appliance, the compressor will run continuously until the wine
cooler reaches a cool enough temperature.
o During this period of time, you should try not to open the door frequently or place bottles
inside of the appliance.
o If the unit is switched off or unplugged, you must allow at least 5 minutes before restarting the
appliance or reconnecting it to your mains supply.